top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How UE knows what bandwidth is used and which is the center frequency to identify center subcarrier ?

+1 vote
891 views

InLTE there are different bandwidths like 1.4,Mhz, 3Mhz, 5Mhz, 10Mhz etc.... so how UE knows it and its cnter subcarrier?

posted Jan 21, 2015 by Shivaraj Kenche

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button
On behalf of Bart (https://www.facebook.com/groups/LTE.Professionals ) -
The eNB is sending this data. This is one of the basic info the eNB sends.
I'm not a Radio guy but I'm guessing this will be send in a common/shared channel.

1 Answer

0 votes
  1. UE sweeps through all supported band one by one in a order. Sweeping is done in a steps of 100KHz (Channel raster for LTE)
  2. Once some energy is detected, using PSS and SSS UE performs time and Frequency Synchronisation. At this stage UE now clearly knows the center frequency
  3. PSS, SSS and PBCH are all of 72 subcarriers (1.08MHz) corresponds to smallest supported bandwidth. Once UE reads PBCH one of the parameter is Bandwidth of operation. After this step UE now clearly knows the bandwidths of operation (1.4/3/5/10/15/20 MHz).

I hope it helps?

answer Jan 21, 2015 by Salil Agrawal
If it is for 700 to 720MHz with bandwidth 20MHz , so where do UE finds the DC subcarrier?
Similar Questions
+4 votes
  1. UE starts scanning entire band and where does it find the DC subcarrier?
  2. How the UE differentiates the subcarrier and center DC subcarrier and what is the difference between normal subcarrier and DC subcarrier?
0 votes

If it is for 700 to 720MHz with bandwidth 20MHz so it finds DC subcarrier at 710Mhz?

LTE: How do the UE knows that a particular subcarrier is a DC subcarrier?

Please do clear my doubt

0 votes

In LTE, there is a few subcarrier frequencies for transmission.

For example, 1200 occupied subcarriers in 20 MHz bandwidth. Assume, I transmit 101010101010101010. How can I know which bit is transmitted by which subcarrier frequency? Is there any calculation?

+4 votes

I am looking at information on which message to refer to first RACH message sent by UE when attaching to network

Which message should I refer to and filter to be applied? Any screenshot would be helpful.

...