top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What does mean of AUT (Application under test) in Software testing?

+2 votes
What does mean of AUT (Application under test) in Software testing?
posted Dec 27, 2014 by Kali Mishra

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

AUT is "Application under test".After designing and coding phase of development cycle,when the application(build) comes under testing then at that time application state is under test,so at that time period that application(build) is called "Application Under test".

answer Dec 28, 2014 by Amit Kumar Pandey
Similar Questions
+3 votes

I'm very new to freediameter. But I'm having some knowledge in freeradius. I believe that diameter is also similar like radius with some additional behaviors.

I have downloaded freediameter and installed properly. But I stuck after that. In radius we can have radtest option to test the basic authentication. But here I don't know how to test the basic authentications to authenticate the user.

When I surf on that, I have found like we need to include DiamEAP extensions also to verify the authentication
And came to know we need to configure mysql since it doesn't have flat file support like radius.

So I start to install mysql also. I have seen the testbed for EAP in TBEAP link. Again I confused with the setup. Is there any simple technique to test the AAA in freediameter. I'll explain my project needs below. Kindly help me how can I proceed with that.

  • I need to implement the authenticate the port MAC (during state change) using freeDiameter protocol.
  • I'll use SDN setup for that, using opendaylight controller. Once i get the port notification from the switch i'll send the username , password info to freediameter client. with that user name and password diameter client needs to send the Access-request packet to freediameter server. The server should validate those info's and return back with Access-Accept/Access-reject messages. Using that info i'll take decision to enable the swicth port or not.
    (I explained the terms in radius, sorry not sure with corresponding terms in freediameter).

For this what conf file I need to edit? What information it should have. How to test the client and server with users information. Please give some clear picture about the setup for my need.

My setup details.
diamEAP - 1.0.0
freediameter - 1.1.4
Ubuntu - 12.04