top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What does UE do after receiving Paging message ?

0 votes

If there is data/call for the UE, SGW sends DL Data Notification to MME, MME sends S1AP Paging message to all the eNodeBs for the given TAI list and finally ENodeB broadcast Paging at DRX interval.

Now UE receives the Paging message and moves from RRC/ECM-Idle state to RRC/ECM-Connected state.

Does UE recalculates PCI again, then reads MIB and SIB1,2 before sending RACH Preamble ?

posted Nov 10, 2019 by Abhishek Kumar Gupta

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button

Similar Questions
+1 vote

Which message EnodeB will communicate to MME after Receiving the Reestablishment Complete message from UE. what else messages will transverse between EnodeB and MME, before sending Reconfiguration message to UE from EnodeB after Reestablishment complete message has been received at EnodeB.

+1 vote

What is the significance of UE capability Information at MME ? What decisions are affected based on the UE capability information ?

+1 vote

After UE handover to target ENB it sent RRC Connection Reconfiguration complete.why UE doing suddenly Tracking Area Update request? Even it is in RRC-Connected State.

+2 votes

During attach procedure, UE sends "Attach Request" along with "RRC Connection Setup Complete", eNodeB sends "Attach Accept" along with "RRC Connection Reconfiguration then why UE does not send "Attach Complete" along with "RRC Connection Reconfiguration Complete" message ? What could be the reason for defining the messages so ?