top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE: What does mean by fully qualified tunnel id (FTEID) in GTP control messages ?

+1 vote
3,236 views

I have seen GTP control messages and found that F-TEID consists of an IP address and 32 bit long Tunnel Id. For example: Create Session Response message contains control plane F-TEID and user plane F-TEIDs. I have a question here, why not only TEIDs are included in Create Session Response message when IP address would be common ? or Does it mean control and user plane both F-TEIDs may have different IP address ?

posted Jul 12, 2018 by Harshita
Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+2 votes

In GTP endpoints were uniquely identified by F-TEIID(IP Address + teid). Each F-TEID pair was treated as a logical tunnel.
GTP will create different tunnel ID's for control and user plane. So, in create session response one F-TEID is for control plane and another is for user plane.
For example, on S5/S8 interface create session response carries PGW control plane F-TEID(PGWC IP Adress + PGW control plane TEID) and PGW user plane F-TEID(PGWU IP Adress + PGW user plane TEID). Here PGWC and PGWU may or may not be the same.

Tunnel-ID's should be created as follows.
- On S11-C interface, control plane tunnel-Id's is per UE.
- On S5/S8-C interface, control plane tunnel-id's per APN/PDN.
- On S5/S8-U interface, user plane tunnel-id'd per bearer.
- On S1-U interface, user plane tunnel-id'd per bearer.

answer Jul 13, 2018 by Althi Rajeswararao

Your answer

Preview

Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.
Similar Questions
+1 vote

GTP tunnel id is a 32-bit long value over one IP address combination. Suppose there are two nodes A and B which has IP addresses X and Y respectively. Is it possible when first GTP tunnel id range gets exhausted then both the nodes starts using different IP address combination and again GTP tunnel id range can be re-used ? If it is impossible then what could be the reason ?

0 votes

Is it possible to establish link between 2 or more Serving Gate Way (S-GW) directly in LTE system? --OR-- SGWs are connected through Packet Data network gate ways (PDN-GW)

...