top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What is Write-Replace warning Procedure in LTE?

+1 vote
What is Write-Replace warning Procedure in LTE?
posted Oct 8, 2013 by Vikram Singh

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

The method of distributing emergency information to LTE radio networks is shown in Figure 1. When the CBC receives a request for emergency information distribution from CBE, it creates the text to be sent to the terminals and specifies the distribution area from the information in the request message.

Next, the CBC sends a Write-Replace Warning Request message to the MME of the specified area. This message contains information such as disaster type, warning message text, message distribution area, Primary Notification information, etc. When the MME receives this message, it sends a response message to the CBC to notify that the message was correctly received. The CBC then notifies the CBE that the distribution request was received and the processing has begun. At the same time, the MME checks the distribution area information in the received message and, if a TAI list is included, it sends the Write-Replace Warning Request message only to the eNB that belong to the TAI in the list. If the TAI list is not included, the message is sent to all of the eNB to which the MME is connected.

When the eNB receives the Write-Replace Warning Request message from the MME, it determines the message distribution area based on the information included in the Write-Replace Warning Request message and starts the broadcast.

answer Oct 8, 2013 by Salil Agrawal
Similar Questions
+3 votes

Please provide some example for Write-Replace Warning message in LTE?

+2 votes

What is the Significance of Repetition Period and Number of Broadcasts Requested IE's in WRITE-REPLACE WARNING REQUEST?

+3 votes

How mme have to react when it didn't receive WRITE-REPLACE WARNING RESPONSE from a eNB after sending WRITE-REPLACE WARNING REQUEST to it.

Because of some S1-AP failure.

1) what if eNB didn't receive the WRWRequest.

2) what if eNB received the WRWRequest and cannot send WRWResponse.

0 votes

I was going through 36.331 specification, SIB10, SIB11 are used for ETWS and SIB12 is used for CMAS i.e Commercial Mobile Alert System. As per my understanding, both comes under the public warning system. Can anyone please explain the major differences between these two ?